(818) 222-7191

OVER 1 MILLION SATISFIED CUSTOMERS

Facebook

Twitter

Google+

YouTube

Search
0 Cart
  • No products in the cart.

Blog

BD Loop Installation for Asphalt or Gravel Roads, Brick Pavers, or Concrete

Directions for quick and easy layout of BD Loops Step #1 Determine the placement of the yoke (intersection of loop and lead-in wire) and secure it in place. Pace off 8 foot 8 inches at 62° for a 4' x 8' or 9 foot 1 inch at 70° for a 3' x 9' loop size and ground stake* or cable tie* the corner in place. See Figure A, Step #1 above. Note: BD Loops are packed from the factory with the corner opposite of the yoke with a folded bend in the loop for easy identification Step...

Continue reading

BD Loop Proper Phasing Installation

Click on image to enlarge Each BD Loop is pre-phased at the factory. This phasing relationship is clearly marked on every loop. The marking consists of a black mark on one of the loop leads as it exits the loop yoke. By placing both loops with the black phase indicator flowing in the same clockwise or counter-clockwise direction and wiring the loop lead-in in series as shown above, the loops will be properly phased. This feature takes the guesswork out of installing two loops to one detector....

Continue reading

Allstar remote transmitters

We carry a full line of Allstar (Allister and Pulsar are all the same manufacturer) gate and garage door openers, parts and accessories. The items listed below are the most common remote control transmitters but not the entire Allstar line. We carry ALL their existing models in the various frequencies from replacement remote transmitters, receivers, keypads, circuit boards and more. Call us or email us if you don't see the part you're looking for.Click HERE to view our entire ALLSTAR page Manufacturer's Instructions If you don't see an item you...

Continue reading