SECTION I - Chamberlain, Sears, LiftMaster, Raynor, Master Mechanic, DoltSECTION I - Chamberlain, Sears, LiftMaster, Raynor, Master Mechanic, Dolt
| SECTION I
- Chamberlain, Sears, LiftMaster, Raynor,
Master Mechanic, Dolt |
| Determine if your motor
unit/receiver system has DIP switches or a smart-learn button. (Locate
the small gray wire antenna. Some models require removing the light
lens.) |
- If the Receiver has 9
DIP switches proceed to TYPE A
- If the Receiver has a yellow, white,
or gray smart-learn button,
proceed to TYPE B
- If the Receiver has a green, red, or orange smart-learn button,
proceed to TYPE C
|
 TYPE A: The
Receiver DIP switch has three positions labeled "+", "0"
and " - ". The "0" setting cannot be used
with the clicker remote.
1) Reset switches: 1
to " - " and positions 2 through 9 to a random setting using
"+" and the " - ". DO NOT USE THE "
0" SETTING.
 2)
Gather any existing remotes and open to expose the DIP switches. Reset
the DIP switch to match the newly coded receiver. Note:
some three button remotes do not have a #1 switch. Match
the 2 through 9 to the receiver. On three button remotes the
large button is now programmed to activate the door.
3) Test all the newly
coded remote controls to be sure that they operate the door before
proceeding to the BRAND MODE SETTING. |
TYPE B: After
determining that the Receiver has a yellow, white or gray learn button:
1) Gather any existing remotes and open to expose
the DIP switches labeled "+", "0" and " -
''.
|
2) Reset switches: 1 to "-" and positions 2 through
9 to a random setting using "+" and the " - ".
DO NOT USE THE " 0" SETTING, SET ALL REMOTES TO
THE SAME SETTING. On three button remotes the large button
is now programmed to activate the door.
3) The recoded remotes must be programmed to the
receiver. Press and release the smart-learn button. Then press and
hold the existing remote push button for three seconds.
4) Test all the newly coded remote controls to be
sure that they operate the door before proceeding to the BRAND
MODE SETTING. |
 |
| TYPE C:
With this type receiver, the existing remotes do not
contain DIP switches. Proceed to BRAND MODE SETTINGS. |
| BRAND MODE
SETTINGS - Set switches on clicker remote |
| FOR TYPE A & B
- Step 1 |
|
Continue to Step 2
|
|
| FOR TYPE C - Step
1 |
|
Continue
to Step 2
|
|
 |
Step 2 - Press
and hold both buttons for 5 seconds or
until LED begins to flash.
Step 3 - When LED flashes, release both buttons
Step 4 - Press the button you wish to operate the
opener (your choice).
For type A & B, proceed
to step 6.
For type C, continue on to Step 5
|
| Step
5 |
A.
Press and release the Smart-Learn button. |
 |
B.
Press and hold button selected in Step 4 for 3 seconds |
|
Step 6 - Programming
is complete, to test, press the button selected to
activate garage door. |
|
|
Close
